Filter
Top Products
5
1. Attach the Front Stabilizer (2) to the Frame (1) with
two M8 x 70mm Carriage Bolts (72), two M8 Curved
Washers (28), and two M8 Black Nylon Locknuts
(56). Make sure that the Front Stabilizer is turned
so the Roller (75) is not touching the floor.
2. Attach the Rear Stabilizer (3) to the Frame (1) with
two M8 x 80mm Carriage Bolts (63), two M8 Curved
Washers (28), and two M8 Black Nylon Locknuts
(56).
3. While another person holds the Handlebar Post (6)
near the Frame (1) as shown, connect the Upper
Wire Harness (16) to the Lower Wire Harness (24).
Next, insert the Handlebar Post into the Frame. Be
careful not to pinch the Wire Harnesses.
Slide the Round Collar (13) down the Handlebar
Post (6) and press it into the Frame (1). Secure the
Round Collar with a M6 x 10mm Screw (26).
Note: There are two sets of holes in the
Handlebar Post (6) so you can attach the
Handlebar Post at either of two height settings.
Choose the setting that you think will be the
most comfortable. Secure the Handlebar Post to
the Frame (1) with four M8 x 25mm Button Screws
(27) and four M8 Curved Washers (28).
2
1
56
28
63
3
3
13
26
27
28
28
1
27
16
24
6
72
28
56
1
2
75
1