Filter
Top Products
8
10. Identify the Left Butterfly Arm (6) by the posi-
tion of the long side of the indicated tube.
S
lide a Weight Stop (31) onto the Butterfly Arm.
G
rease an M10 x 57mm Bolt (26). Attach the Left
Butterfly Handle (7) to the Left Butterfly Arm (6)
with the Bolt and an M10 Nylon Locknut (51).
Do
not overtighten the Locknut; the Handle must
be able to pivot easily.
Repeat this step with the Right Butterfly Arm
(not shown) and Right Butterfly Handle (not
shown).
12. Route the Cable (34) through the Lat Tower (9)
and over the Pulley (36). Make sure that the
Cable is under the lat rest bar. Attach the
Pulley inside the Lat Tower with an M10 x 57mm
Bolt (26), two M10 Washers (50), two 7.5mm
Spacers (35), and an M10 Nylon Locknut (51).
13.
Insert an M10 x 20mm Bolt (47) into the bracket
on the Weight Carriage (10).
Slide the W
eight Carriage (10) onto the Lat Tower
(9).
Make sure the bracket on the Weight
Carriage and the lat rest on the Lat Tower (see
step 12) are on the opposite sides.
Attach the Cable (34) to the M10 x 20mm Bolt
(47) with an M10 Nylon Locknut (51).
11. Grease an M10 x 138mm Bolt (45). Attach the
Left Butterfly Arm (6) to the indicated Upright (4)
with the Bolt and a Butterfly Knob (55).
Repeat this step with the Right Butterfly Arm
(56).
10
11
12
13
51
26
31
7
6
45
55
Grease
Lat
Rest
Tube
56
4
35
9
51
50
50
26
36
35
10
51
34
9
47
34
Bracket