Filter
Top Products
7
5. The Console (4) requires four “D” batteries (not includ-
ed); alkaline batteries are recommended. IMPOR-
TANT: If the exercise cycle has been exposed to
cold temperatures, allow it to warm to room tem-
p
erature before inserting batteries into the
Console. If you do not do this, the console dis-
plays or other electronic components may become
damaged. Remove the battery cover from the back of
the Console. Next, insert four batteries into the battery
compartment; make sure that the batteries are ori-
ented as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
5
4
B
atteries
Battery
C
over
Batteries
7. Attach the Seat (9) and the Backrest Bracket (3) to the
Seat Bracket (11) with four M6 x 42mm Button
Screws (81) and four M6 Washers (44) as shown.
Start all four Button Screws before you tighten any
of them.
7
11
44
44
81
81
3
9
6. While another person holds the Console (4) near the
Upright (2), connect the console wire harnesses to the
Upper and Main Wire Harnesses (42, 43). Insert the
excess wire downward into the Upright.
Attach the Console (4) to the Upright (2) with four
M4 x 16mm Round Head Screws (80). Be careful to
avoid pinching the Wire Harnesses (42, 43).
2
6
4
80
43
Console
Wire
Harnesses
80
Avoid pinching and
damaging the wires.
42