Filter
Top Products
11
8. IMPORTANT: To avoid damaging the Pulse
Crossbar (31), do not use power tools and do
not overtighten the #10 x 3/4" Screws (13).
Orient the Pulse Crossbar (31) as shown. Attach
the Pulse Crossbar to the Handrails (71) with
four #10 x 3/4" Screws (13) and four #10 Star
Washers (11). Start all four Screws, and then
tighten them.
Make sure that the Upright Wire (70) is not
pinched. Firmly tighten the four 5/16" x 2 3/4"
Screws (10).
8
13
13
11
11
10
10
71
31
70
9. With the help of a second person, hold the con-
sole assembly near the left Handrail (71) and the
right Handrail (not shown).
Connect the ground wire from the console
assembly to the Console Ground Wire (89) on
the Pulse Crossbar (31).
Connect the Upright Wire (70) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
9
Console
Assembly
70
70
Wire
Tie
Console
Wire
Console
Wire
71
89
Ground
Wire
31
71