Filter
Top Products
5
2
75
75
1
72
45
1. Identify the Front Stabilizer (2), which has Wheels
(75) near its ends. Attach the Front Stabilizer to the
front of the Frame (1) with two M10 x 75mm
Carriage Bolts (72) and two M10 Nylon Locknuts
(45). Make sure that the Front Stabilizer is turned
so the Wheels are not touching the floor.
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M10 x 82mm Carriage Bolts (63)
and two M10 Nylon Locknuts (45).
3. While a second person holds the Handlebar Post (6)
near the Frame (1) as shown, connect the Upper
Wire Harness (16) to the Lower Wire Harness (77).
Carefully slide the Handlebar Post (6) onto the
Frame (1); be careful to avoid pinching the Wire
Harnesses (16, 77). Attach the Handlebar Post to
the Frame with four M8 x 25mm Button Screws (27)
and four M8 Split Washers (70).
2
3
63
3
6
27
27
70
1
16
77
70
4. Connect the two Pulse Wires (86) to the two wires
extending from the Console (9). Next, connect the
Upper Wire Harness (16) to the back of the Console.
Insert all wires into the Handlebar Post (6).
Attach the Console (9) to the Handlebar Post (6)
with four M4 x 16mm Screws (90). Be careful to
avoid pinching the wires.
9
86
16
Console
Wires
6
90
4
45
45
1
1