Filter
Top Products
7
2. With the help of a second person, carefully tip
the treadmill onto its right side as shown.
Insert the other Extension Leg (89) into the base
o
f the Uprights (84) as shown. Hold two
Extension Leg Nuts (67) in the bottom of the
Extension Leg. Next, insert two Base Leg Bolts
(65) into the top of the Extension Leg, and firmly
tighten the Base Leg Bolts into the Extension
Leg Nuts.
Attach two Base Pads (82) to the base of the
Uprights (84) with two 3/4" Tek Screws (22).
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (82) are
on the floor and the Uprights (84) are in a
vertical position.
84
22
82
6
5
67
2
3. Identify the Latch Assembly (29). Remove the
tie from the end of the tube. Make sure that the
sleeve has been slid over the indicated hole and
that the Latch Knob (97) is locked into the indi-
cated hole. Pull on the sleeve to make sure
that it is locked into place.
3
89
8
2
4. Raise the Frame (58) to the position shown.
Have a second person hold the Frame until
this step is completed.
Remove the plastic ties from the ends of the
Latch Assembly (29).
Orient the Latch Assembly (29) so that the large
barrel and the Latch Knob (97) are positioned as
shown; make sure that all of the holes are
aligned. Attach the lower end of the Latch
Assembly to the bracket on the Uprights (84)
with the Lower Latch Shock Bolt (39) and a
Latch Shock Nut (30).
Then, attach the upper end of the Latch
Assembly (29) to the bracket on the Frame (58)
with the Upper Latch Shock Bolt (50) and a
Latch Shock Nut (30). Note: It may be neces-
sary to move the Frame back and forth to align
the Latch Assembly with the bracket.
29
30
30
84
39
58
4
50
97
Large
Barrel
97
Sleeve
Hole
Tube
29