Filter
Top Products
7
2. Attach a Wheel (90) to the Base (60) with a 3/8"
x 2" Bolt (3) and a 3/8" Locknut (11). Do not
overtighten the Locknut; the Wheel must
turn freely.
See the inset drawing. Cut the plastic tie near
the Upright Wire (86).
60
3
11
2
90
1
. Make sure that the power cord is unplugged.
W
ith the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire
(86) to the Base (60). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach two Base Feet (88) to the Base (60) in the
locations shown with two #8 x 1" Tek Screws (2)
and two Base Foot Spacers (89). Then, attach
two Base Feet (88) with two #8 x 1" Tek Screws
(2).
1
60
A
B
2
53
2
2
8
8
88
2
86
88
88
89
89
Hole
Cut
86