Razor MX500 Bicycle User Manual


 
BEFORE YOU BEGIN
2
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
DIRT ROCKET. The Dirt Rocket
has been built to certain Razor
design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may or may not be
compatible and will void your
warranty.
Required Tools
5mm and 6mm
Allen wrenches
(Included)
2.5mm Allen wrench
(Not Included)
Spoke tightener
(Included)
Charger
Charger
Plug
Charger
Port
Phillips
screwdriver
(Included)
Bicycle tire pump
for Schrader valve tires,
with pressure gauge
(Not Included)
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the Dirt Rocket is 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF” BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 30 minutes for assembly.
Allow up to 12 hours for initial charge (see page 5 for charging information).
Speed Control
Drive
Chain
Front Fork
Brake Lever
10mm, 14mm and 17mm
open wrenches
(Included)
19mm open wrench
(Not Included)
Brake Lever
Brake Lever