Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials.
D
o not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the
walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there
is lubricant on top of the walking belt, simply wipe it off with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver , adjustable
wrench , scissors , rubber mallet , and needlenose pliers .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly.
Note: If a part is not in the parts bag, check to see if it is preattached to
one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Extra hardware may be included.
6
M10 Flat Washer
(14)–2
Nut (16)–4
M8 x 15mm
Bolt (8)–6
M10 Star
Washer (9)–6
M8 Star
Washer (5)–6
M4.2 x 19mm
Screw (10)–6
M5 Star
Washer (7)–2
M10 x 75mm Bolt (2)–4
M10 x 60mm Bolt (1)–2
M5 x 16mm
Screw (85)–2
M4 x 10mm
Screw (84)–1
M4.2 x 19mm Tek
Screw (26)–6
Wheel Housing Bolt (13)–4
M8 x 58mm Bolt (13)–4
M8.5 Washer
(32)–4
Extension Leg Nut
(43)–4
1. Make sure that the power cord is unplugged.
Position the Base (52) and Extension Legs (45)
upside-down as shown.
Attach six Base Pads (63) to the Base (52) and
the Extension Legs (45) with six M4.2 x 19mm
Tek Screws (26).
1
52
26
26
63
63
63
26
63
26
63
26
45
63
26
45