ProForm 30464.0 Treadmill User Manual


 
1
1
1
1
14. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. One hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet,
place a mat under the treadmill.
13. Attach the Latch Housing (48) to the Left
Upright (53) with two M4.2 x 19mm Screws (10);
start both Screws before tightening either of
them. Make sure that the large hole in the
Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
10
Pin
Spring
Collar
Knob
48
53
Large Hole
13
12. Lower the Uprights (53, 54). See the lower
drawing. Position the Uprights so that the Frame
(
51) is centered between them.
F
irmly tighten the two M10 x 60mm Bolts (1)
and the four M10 x 75mm Bolts (2). Be careful
not to overtighten the Bolts.
Raise the Uprights (53, 54).
1
2
2
51
1
53
51
54
Top View
5
3, 54