Filter
Top Products
6
ASSEMBLY
A
ssembly requires two people.
S
et the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
2. With the help of a second person, carefully lower the
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) re-
main in the Uprights.
Tighten two 1/2” Screws (67) into each Upright and
Extension Leg.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
67
102
69
99
99
Frame
69
67
102
3. Remove the Console Back Screws (83) from the
Console Back (88). Remove the Console Back.
Loosen the four Console Base Screws (80) until they
extend about 1/2”.
3a
80
80
80
80
3b
88
83
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into
the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other
side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(102) are resting flat on the floor.
102
99
1
2