10
HOW TO TURN ON THE POWER
Plug in the power cord (see HOW TO PLUG IN
THE POWER CORD on page 8).
Locate the on/off
s
witch on the treadmill
near the power cord.
M
ove the on/off
switch to the on posi-
tion.
Stand on the foot rails
of the treadmill. Find
the clip attached to the
key and slide the clip
onto the waistband of
your clothing. Next, insert the key into the console.
After a moment, the displays and various indica-
tors will light.
Test the clip by carefully taking a
few steps backward until the key is pulled
from the console. If the key is not pulled from
the console, adjust the position of the clip as
needed.
HOW TO USE THE MANUAL MODE
Insert the key fully into the console.
See HOW TO TURN ON THE POWER above.
Select the manual
mode.
When the key is in-
serted, the manual
mode will be selected
and the Manual Control
indicator will light. If a
program has been selected, press the Program
button repeatedly to select the manual mode.
Press the Start button or the Speed
▲
▲
button to
start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move at 1 mph. Hold the handrails
and begin walking. As you exercise, change the
speed of the walking
belt as desired by
pressing the Speed
buttons. Each time a
button is pressed, the
speed setting will
change by 0.1 mph; if a
button is held down, the speed setting will change
in increments of 0.5 mph. The speed range is 0.5
mph to 10 mph.
To stop the walking belt, press the Stop button.
The Time/Segment Time display will begin to
flash. To restart the walking belt, press the Start
button or the Speed
▲
▲
button.
C
hange the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline buttons. Each time
one of the buttons is
pressed, the incline will
change by 0.5%. The
incline range is 1.5% to 10%. Note: After the
buttons are pressed, it may take a moment for the
treadmill to reach the selected incline setting.
Follow your progress with the LED track and
the displays.
The LED Track—When
the manual mode or an
iFit.com program is se-
lected, the program dis-
play will show an LED
track representing 1/4
mile. As you exercise,
the indicators around the track will light in sequence
until you have completed 1/4 mile. A new lap will
then begin.
Distance/Laps/
Incline display—This
display shows the dis-
tance that you have
walked and the number of
1/4-mile laps you have
completed. The display will alternate between one
number and the other every seven seconds. The
LAPS indicator will light when the number of laps
is shown. In addition, each time the Incline buttons
are pressed, the display will show the current in
-
cline setting for several seconds.
Time/Segment Time dis-
play—When the manual
mode or an iFit.com pro-
gram is selected, this dis-
play will show the elapsed
time. When a personal
trainer program is selected, the display will show
both the time remaining in the program and the
time remaining in the current segment of the pro-
gram. The display will alternate between one num-
ber and the other every seven seconds. The SEG
indicator will light when the segment time is shown.
5
4
3
2
1
3
2
1
On
Position