Filter
Top Products
7
4. Attach the Water Bottle Holder (18) to the
Handlebar Post (6) with two M4 x 19mm
Screws (33).
6. The Console (9) requires four 1.5V “D” batteries
(not included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Press the tab on the bat-
tery cover and remove the battery cover. Next,
insert four batteries into the Console. Make sure
that the batteries are oriented as shown by the
diagram inside the battery compartment. Then,
reattach the battery cover to the Console.
Note: The Console (9) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the telephone num-
ber on the front cover of this manual. Plug one
end of the power supply into the jack on the con-
sole. Plug the other end of the power supply into an
appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
4
6
18
33
5. Have a second person hold the Handlebar (7) near
the Handlebar Post (6). Connect the Right
Controller Wire (65), which is marked with a tag, to
the right connector on the Split Wire Harness,
which is also marked with a tag. Then, connect the
Left Controller Wire (54) to the left connector on the
Split Wire Harness (25).
Attach the Handlebar (7) to the Handlebar Post (6)
with two Black M10 x 50mm Button Screws (64),
two Black M10 Curved Washers (61), two M10
Curved Washers (36), and two M10 Nylon
Locknuts (48). Be careful to avoid pinching the
wires.
5
48
36
55
25
25
61
61
54
65
7
6
64
36
6
Battery
Cover
Batteries
9