Filter
Top Products
12
HOW TO USE THE MANUAL MODE
Note: If there is a sheet of clear plastic on the face
of the console, remove the plastic.
1. Begin pedaling or press any button on the con-
sole to turn on the console.
A moment after you begin pedaling or press a but-
ton, the display will light.
2. Select the manual mode.
Each time you turn
on the console, the
manual mode will
be selected. If you
have selected a
program, reselect
the manual mode
by pressing the Program button repeatedly until the
word MANUAL appears in the lower left corner of
the display.
3.
Change the resistance of the pedals as desired.
As you pedal,
change the resis-
tance of the pedals
by pressing the
increase and
decrease buttons
repeatedly. There
are sixteen resistance levels. Note: After you press
the buttons, it will take a moment for the pedals to
reach the selected resistance level.
4.
Follow your progress with the display.
The upper left corner of the display will show
the elapsed time. Note: When a program is select-
ed, the display will show the time remaining in the
program instead of the elapsed time.
The lower left corner of the display will show the
distance you have pedaled, in miles or kilometers.
The upper right corner of the display will show
the approximate number of calories you have
burned. The upper right corner of the display will
also show your heart rate when you use the hand-
grip pulse sensor (see step 5 on page 13).
The lower right corner of the display will show
your pedaling pace in miles or kilometers per hour.
The center of the display will show the resistance
level of the pedals for a few seconds each time the
resistance level changes.
You can also view selected information at a larger
size. Press the Display button repeatedly to view
time and distance information, time and calorie
information, or time and pace information. Press
the Display button again to view all information.
The console has three backlight options. The “On”
option keeps the backlight on while the console is
on. To conserve the batteries, the “Auto” option
keeps the backlight on only while you are pedal-
ing. The “Off” option turns the backlight off. To
select a backlight option, first press and hold down
the Program button for several seconds. Next,
press the increase button to select the desired
backlight option. Then, press the Program button to
save your selection.