Filter
Top Products
8
7. Attach the Console Back (104) to the console assembly
with five 3/4” Screws (33).
104
33
Console Assembly
33
33
7
76
52
77
101
80
6. Turn the Console (101) upside-down; be careful not to
scratch the Console. Remove the bands and the Console
Back (104) (see drawing 6) from the Console. If the four
Pulse Bar Screws (76) (only two are shown) are in the
Console Frame (80), remove them.
Hold the ends of the Pulse Bar (77) against the Console
Frame (80) as shown. Connect the pulse wire in the
Console (101) to the pulse wire in the Pulse Bar (see the
inset drawing). The connectors should slide together
easily and snap into place. If the connectors do not
slide together easily and snap into place, turn one con-
nector and try again to connect them. Attach the Pulse
Bar to the Console Frame with the four Pulse Bar Screws
(76). Firmly tighten the Pulse Bar Screws. Be careful
not to damage the wires.
Attach the ring on the ground wire to the Console Frame
(80) with a 1/2” Ground Screw (52). Note: There are no
wires on the other side of the Pulse Bar (77).
Ground
Wire
Pulse
Wire
Pulse
Wire
6
5. Identify the Right Handrail (120) and the Left Handrail
(108) (there is an identification sticker on each Handrail).
Hold the
Right Handrail near the Right Upright (119).
Insert the Wire Harness (118) into the large hole in the
Right Handrail and out of the upper end as shown.
Next, hold the Right Handrail (120) against the Right
Upright (119). Tighten a 4” Bolt (121) three to four turns
into the Right Upright and the lower end of the Right
Handrail. Then, tighten two 5/16” x 1” Bolts (113) into the
upper end of the Right Handrail and the Right Upright.
Be
careful not to drop the Bolts into the Handrail. If nec-
essary, raise or lower the Handrail to thread the 5/16” x
1” Bolts into the Upright.
Firmly tighten all three Bolts.
Attach the Left Handrail (108) to the Left Upright (111) as
described above. Note: There is not a wire harness in the
Left Upright.
5
119
111
118
113
108
113
121
120
121