Filter
Top Products
10
10. Set the Pulse Bar (90) on the Left and Right
Uprights (77, 92). Attach the Pulse Bar with four
#10 x 3/4" Screws (4) and four #10 Star
Washers (12). Start all four Screws before
firmly tightening any of them. Be careful not
to pinch the Wire Harness (91).
Firmly tighten the four 5/16" x 1 3/4" Bolts
(5).
77
4
12
4
12
5
92
90
5
10
91
9. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Remove the two #8 x 3/4" Screws (1). Lift
off the Pulse Bar (90). Save the Pulse Bar and
t
he two Screws for assembly steps 10 and
12.
Console
Assembly
90
1
9
11. While a second person holds the console as-
sembly near the Pulse Bar (90), connect the
Console Ground Wire (89) on the Pulse Bar to
the ground wire from the console assembly.
Connect the console wire to the Wire Harness
(91). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
then try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Lay the wires inside
the bottom of the Pulse Bar (90).
11
91
Console
Assembly
Console Wire
92
89
91
90
Console
Wire
Ground
Wire