Filter
Top Products
3. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin
into the Latch Housing (82), and tighten the knob back
onto the pin.
Knob
Collar
Spring
Pin
82
3
4. See drawing 4c. With the help of a second person, hold
the Console Base (101) near the Uprights (97). Look
under the Console Base and locate the wires on the
sides of the Console Base. Make sure that the wires are
not routed through the openings for the Trays (109,
111). Drawing 4a shows the correct route for the wires.
Drawing 4b shows an incorrect route.
See drawing 4c. Cut the plastic ties holding the Wire
Harness (74) and the pulse wire in the Uprights (97).
Locate the Wire Harness (74) and the pulse wire in the
Uprights (97). Connect the Wire Harness and the pulse
wire to the connectors on the sides of the Console Base
(101). Make sure to connect the connectors properly
(see the inset drawings). IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
The connectors should slide together easily and
snap into place. If the connectors do not slide together
easily and snap into place, turn a connector and try to in
-
sert it again. Insert the excess Wire Harness and pulse
wire up into the Console Base.
101
111
109
97
97
4c
74
Pulse
Wire
6
4a
4b
Correct
Incorrect
74
2. With the help of a second person, carefully tip the
Uprights (97) down as shown. (Note: It may be helpful to
place your foot on one of the Extension Legs [92] as you
tip the Uprights.)
Make sure that the Extension Legs
remain in the Uprights.
Attach the Extension Legs (92) with four 1” Tek Screws
(80) and two Base Pads (99) as shown. Tighten the Tek
Screws without the Base Pads first. Note: The indi-
cated center holes are not used.
Attach the other two Base Pads (99) to the base of the
Uprights (97) in the locations shown with two 1” Tek
Screws (80).
With the help of a second person, raise the Uprights (97)
to the vertical position.
80
80
80
99
92
80
80
92
97
99
Not
Used
Not
Used
97
2
99
99