Filter
Top Products
11.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 25). To protect the
floor or carpet from damage, place a mat under the treadmill.
8a
8. Refer to drawing 8a. Attach the matching Left Bottom
Handgrip (82) with three 1/2” Screws (33).
Attach the Right Top Handgrip and the Right Bottom
Handgrip (not shown) as described above.
33
82
8b
Refer to drawing 8b. Press the Latch Knob Sleeve (104)
into the Left Upright (64). If necessary, use a rubber mal-
let to tap the Latch Knob Sleeve into the Upright.
Remove the Latch Knob (32) from the Latch Pin (111).
Make sure that the Latch Pin Collars (100) and the Spring
(105) are on the Latch Pin as shown. Insert the Latch Pin
into the Latch Knob Sleeve (104) and the Left Upright
(64), and tighten the Latch Knob onto the Latch Pin.
32
64
111
100
105
104
9
9. Attach a Wheel (58) to the right side of the Base (114)
with a Wheel Bolt (56) and a Nut (3) as shown.
Attach a Wheel to the left side of the Base (not shown) in
the same way.
58
56
3
114
10
10.Carefully lower the Uprights (55, 64) as shown.
Press the Console Back (40) onto the back of the
Console Base (38). Make sure that Console Back and
the Console Base are mated correctly and that no
wires are pinched. Tighten two 1/2” Silver Screws (115)
into the indicated holes. Tighten 3/4” Screws (37) into the
remaining holes in the Console Back.
Make sure that the side of the Left Upright (64) is flush with
the left side of the Base (114). Firmly tighten, but do not
overtighten, the two Upright Bolts (13) in the left side of the
Base. Then, tighten the two Upright Bolts (not shown) in
the other side of the Base. Make sure that the Right
Upright (55) is flush with the right side of the Base (114).
Insert the Left and Right Cup Holders (39, 59) into the
large holes in the Console Base (38). If there is a small
hole under each Cup Holder, the two Small Clamps (47)
should be attached. Refer to the inset drawing. Loop a
Small Clamp through the hole in the bottom of a Cup
Holder and attach it with a 3/4” Screw (37). Attach a Small
Clamp to the other Cup Holder in the same way.
Raise the Uprights (55, 64) back to the vertical position.
Note: After assembly is completed, some extra hardware
may be left.
40
39
59
38
37
115
115
13
64
55
114
8
37
47