Filter
Top Products
5
5. Tighten tighten a 3/4” Tek Screw (35) into the right side
of the Crossbar (46) and the Right Upright (55).
Attach the Console Base (38) to the Uprights (55, 64)
with four 1/2” Screws (33). Make sure that the Wire
Harness (49) is not pinched.
38
6. Tighten the 1/2” Tek Screw (116) in the left side of the
Crossbar (46).
Orient one of the Handgrip Extensions (34) so the bottom
is open as shown, and insert it as far as possible into the
post on the left Upright (64). If necessary, tap the Handgrip
Extension with a rubber mallet to fully insert it. Attach the
Handgrip Extension with two 3/4” Tek Screws (35), one to-
wards the front of the post, and the other towards the back.
Attach the other Handgrip Extension to the post on the
right Upright (not shown) in the same way.
34
35
116
46
35
64
Post
6
49
33
64
55
46
35
33
7
7. See the inset drawing. Identify the Left Top Handgrip (31);
there are identifying marks inside the Handgrips. Set the
Left Top Handgrip on the left Handgrip Extension (34).
Insert two 1/2” Screws (33) into the two holes in the
Handgrip Extension indicated by the arrows. Tighten
the Screws into the Left Top Handgrip. Important: Do
not tighten the Screws into the plastic bosses on the
bottom of the Left Top Handgrip.
31
Bosses
64
33
34
7
31
43
4
4. Loosely thread a 1/2” Tek Screw (116) into the left side of
the Crossbar (46).
116
(Leave loose)
46
Open side