Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver ,
adjustable wrench , and rubber mallet .
2. Identify the Right and Left Uprights (55, 64); the Left
Upright has a hole near the bend.
Hold the Right Upright (55) near the Base (114) as shown.
Straighten the Wire Harness (49), and feed the Wire
Harness into the lower end of the Right Upright and out of
the top. Make sure that the Right Upright is oriented so
that it bends in the direction shown. Hand tighten two
Upright Bolts (13) with Washers (2) into the bottom of the
Base (114) and the lower end of the Right Upright (55).
Attach the Left Upright (64) as described above. Note:
There is not a wire harness for the Left Upright.
2
1. Note: Use the PART IDENTIFICATION CHART in the
center of this manual to identify small parts used
during assembly.
Do not plug in the power cord until all the assembly
steps are completed.
With the help of a second person, carefully tip the
treadmill onto its left side. Partially fold the Frame (51) as
shown, so that the treadmill will be more stable. Do not
fully fold the treadmill until it is completely assem-
bled.
Attach six Base Pads (44) to the bottom of the Base
(114) with six 1” Tek Screws (86). Note: Only three Tek
Screws are shown.
86
86
44
51
44
114
2
64
Bend
55
Hole
114
13
49
1
3
3. With the help of a second person, carefully tip the tread-
mill back down so the Uprights (55, 64 [not shown]) are
vertical. Make sure that the end of the Wire Harness
(49) does not fall into the Right Upright.
Cut off the plastic ties attaching the Console Base (38) to
the Console Back (not shown). Set the Console Base on
the Right Upright (55) as shown. Next, connect the Wire
Harness (49) to the indicated connector on the back of
the Console Base. The connectors should slide easily
and snap into place. If the connectors do not slide easily
and snap into place, turn a connector and try again.
Attach the end of the Ground Wire (79) to the Right
Upright with a 3/4” Silver Screw (48).
38
49
55
48
79
6