Filter
Top Products
9
I
nsert the key fully into the power switch.
Inserting the key will
not turn on the dis-
p
lays. The displays will
turn on when the
ON/RESET button is
pressed or when the
walking belt is started.
Note: If you just
installed batteries, the displays will already be on.
Reset the speed control.
Slide the speed control
to the RESET position.
Note: Each time the
walking belt is
stopped, the speed
control must be
moved to the RESET
position before the
walking belt can be
restarted.
Start the walking belt.
After you have moved the speed control to the
RESET position, slowly slide it to the right until the
walking belt begins to move at slow speed.
Carefully step onto the walking belt and begin ex-
ercising. Change the speed of the walking belt as
desired by sliding the speed control.
To stop the walking belt, step onto the foot rails
and slide the speed control to the RESET position.
Adjust the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
top or bottom of the in-
cline control until the
desired incline level is
reached.
Follow your progress with the LED track and
the four displays.
The LED Track—The
LED track represents a
distance of 1/4 mile. As
you exercise, the indi
-
cators around the track
will light one at a time
until you have
com-
pleted 1/4 mile. A new lap will then begin.
D
ISTANCE display
—
This display shows the
d
istance that you have
walked or run, in miles.
CALS/FAT CALS
display—This display
shows the approximate
numbers of
calories
and
fat calories
you
have burned. (See FAT
BURNING on page 13.)
Every seven seconds, the display will change from
one number to the other. Arrows in the display will
indicate which number is currently shown.
SPEED display—This
display shows the
speed of the walking
belt, in miles per hour.
TIME display—This
display shows the
elapsed time.
To reset the displays at
any time, press the
ON/RESET button.
When you are finished exercising, stop the
walking belt and remove the key.
Step onto the foot rails, stop the walking belt and
remove the key from the console. The displays will
turn off about five minutes after the key is removed.
Note: To conserve the batteries, the displays
will automatically turn off any time that the
walking belt is stopped and the ON/RESET
button is not pressed for five minutes.
6
5
4
3
2
1
Arrow