Filter
Top Products
5
1
. With the help of a second person, carefully raise the
t
readmill to the upright position. While a second person
tips the treadmill to one side and holds it, insert one of
the Extension Legs (103) into the treadmill as shown.
Make sure that the Extension Leg is turned so the
Warning Decal (20) is on top.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
20
103
1
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 10. Follow the instructions in step 2 to lower
the treadmill.
Attach the latch support to the center hole in the left
Upright (82) with a 3/4” Screw (89).
Make sure that the
Screw is tight, but do not overtighten it; if the Screw
is overtightened, the latch will not slide smoothly.
Remove the tape from the Latch Assembly (77). Be
careful to hold the parts in place. Inset drawing (a)
shows how the Latch Assembly fits together. Refer to
inset drawing (b). Insert the springs into the bracket as
shown. Make sure the tabs are touching the bracket
and the back end of the latch is flush with the bracket.
Attach the Latch Assembly (77) to the left Upright (82)
with two 3/4” Screws (89).
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
d
ispose of the packing materials until assembly is completed.
A
ssembly requires the included allen wrench
and your own phillips screwdriver and adjustable wrench .
3.
Slide the upper end of a Handrail (75) onto the right
Upright (82) as shown. Note: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to slide it fully onto the Upright. Next, pivot
the lower end of the Handrail down,
push it toward the
right Upright, and then align it with the indicated hole.
Slide the other Handrail (75) onto the left Upright (82) as
described above.
82
75
75
82
Hole
3
B
A
77
89
89
82
2
Flush
Bracket
a
b
Latch
Support
Latch
Spring
Spring
Tabs