Filter
Top Products
8
90
5. Set the console assembly on the Handrails (71); insert
the excess wiring down into the right Handrail. Attach the
c
onsole assembly with four 3/4” Screws (2), two Console
Bolts (90), and two 1/4” Star Washers (96) as shown.
M
ake sure that no wires are pinched. Start all four
Screws and both Console Bolts before tightening
any of them.
2
90
96
96
2
71
71
5
Console Assembly
8. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.
7. Attach the Latch Housing (29) to the left Upright (69) with
two 3/4” Screws (2). Make sure that the large hole in
the Latch Housing is on the side shown. Do not over-
tighten the Screws.
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Then, insert the
pin into the Latch Housing (29), and tighten the knob
back onto the pin.
Place the Weights (not shown) on the Weight Rack
(102).
2
29
69
7
Knob
Pin
Collar
Spring
6. Attach the Weight Rack (102) to the Uprights (69) with
two Rack Screws (101).
102
101
101
69
6
102