Filter
Top Products
8
5. See the left inset drawing. Identify the two
Frame Spacers (79). Open the included packet
of grease, and apply grease to both sides of
both Frame Spacers. Then, identify the outer
side of each Frame Spacer.
Hold a Frame Spacer (79) between the Right
Upright (78) and the Lift Frame (65), with the
outer side of the Frame Spacer facing the
Right Upright. Attach the Right Upright to the
Lift Frame with a 3/8" x 2 1/2" Bolt (1), a 3/8"
Washer (10), and a 3/8" Nut (13); do not
tighten the Bolt yet.
5
78
1
1
79
79
10
13
13
65
10
65
78
4. Raise the Uprights (77, 78), and position the
Base (85) near the treadmill as shown.
See the far right drawing. Tie the wire tie in the
l
ower end of the Right Upright (78) around the
Upright Wire (74). Then, pull the other end of the
wire tie until the Upright Wire is routed through
the Right Upright.
Make sure that the end of the Upright Wire
(74) does not fall into the Right Upright (78).
4
74
Wire Tie
85
74
78
77
Large
Hole
Wire
Tie
79
Grease
Outer Side