Filter
Top Products
10
9. Set the Left Handrail (69) and the Right Handrail
(71) on a level surface.
Attach the Handrails (69, 71) to the Handrail
Bracket (70) with four 1/4" x 1 1/2" Bolts (3) and
four 1/4" Nuts (4). See the lower drawing.
Make sure that the Nuts sit inside the indi-
cated square holes in the Handrails. Start all
four Bolts, and then tighten each of them.
9
3
3
4
4
4
4
69
70
71
5
5
78
2
2
2
5
8. Insert the wires into the Right Upright (78). Next,
insert the brackets on the console assembly into
the Right Upright and the Left Upright (77). Be
c
areful not to pinch any wires.
A
ttach the console assembly with four 5/16" x
3/4" Bolts (2) and four 5/16" Star Washers (5).
Start all four Bolts, and then firmly tighten
each of them.
77
Console
Assembly
8
7
71
69
86
7
10. Hold the Pulse Assembly (72) near the Handrail
Bracket (70). Orient the Pulse Assembly so
that the indicated plastic post will fit into the
hole in the Right Handrail (71). Connect the
two Pulse Ground Wires (86) to the ground
wires on the Pulse Assembly.
Next, insert the wire harness on the Pulse
Assembly (72) into the top of the Handrail
Bracket (70) and out of the side as shown.
Set the Pulse Assembly (72) on the Handrails
(69, 71). Insert the excess ground wire into the
Handrails. Attach the Pulse Assembly with four
#8 x 3/4" Screws (7). Be careful not to over-
tighten the Screws. Be careful not to pinch
any wires.
Post
72
Square Holes
10
2
69
71
70
Pulse
Wires
Wire Harness