Filter
Top Products
7
10. Press three 2” Square Inner Caps (28) into the
Butterfly Top Frame (33).
Attach the Butterfly Top Frame (33) to the brackets on
the Butterfly Upright (1) and the Weight Top Frame
(66) with four 5/16” x 2 3/4” Bolts (89), two Support
Plates (94), and four 5/16” Nylon Locknuts (64).
10
28
94
94
1
66
28
28
33
64
64
89
89
9. Place the Weight Top Frame (66) on the indicated
brackets on the Uprights (1, 2). Note: When attach-
ing the Weight Top Frame make sure that the tops
of both Weight Guides (15) are in back of the Top
Frame, as shown in step 10.
Attach the Weight Top Frame (66) to each Upright (1,
2) with two 3/8” x 2 3/4” Bolts (46), a Small Support
Plate (26), and two 3/8” Nylon Locknuts (50).
Tighten all of the Nylon Locknuts (64) used in
steps 5 and 6.
9
50
15
66
46
26
46
26
50
2
1
Bracket
8. Place two Weight Bumpers (51) over the indicated
holes in the Weight Base (5). Slide a Weight Guide
(15) into each of the holes.
Attach the indicated Weight Guide (15) to the Weight
Base (5) with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat
Washers (48), and a 3/8” Nylon Locknut (50).
Slide twelve Weights (21) onto the Weight Guides
(15). Make sure the Weights are turned so the pin
grooves are on the bottom.
Identify the Long Weight Tube (96), which has twelve
holes in it. Press a Weight Tube Bumper (18) into the
lower end of the Long Weight Tube. Slide the Weight
Tube into the Weights (21).
Slide a Top Weight (16) onto the Weight Guides (15).
Make sure the Top Weight is turned so the groove
fits over the pin on the Long Weight Tube (96).
8
15
16
46
48
21
51
96
18
Groove
Pin
Groove
Pin
48
5
50