Filter
Top Products
20
56. Press a 1” x 2” Inner Cap (83) into each end of a
Backrest Adjustment Frame (70). Press a 1 1/4”
Square Inner Cap (35) into the tube on the Backrest
Adjustment Frame.
Insert a 1/4” x 1 1/2” Carriage Bolt (101) into the cen-
ter hole in a Seat Plate (65). Attach the Seat Plate to
the Press Backrest (99) with two 1/4” x 3/4” Bolts (49).
Insert the 1/4” x 1 1/2” Carriage Bolt (101) into the
indicated hole in the Backrest Adjustment Frame (70)
and secure it with a 1/4” Flat Washer (71) and a 1/4”
Nylon Locknut (68). Secure the other end of the
Backrest (99) with a 1/4” x 1 1/2” Bolt (82) and a 1/4”
Flat Washer (71).
Pull the indicated Adjustment Knob (78) and slide the
tube on the Backrest Adjustment Frame (70) into the
Press Upright (2). Snap the Knob into a hole in the
Frame and turn it clockwise until it is tight.
57. Insert a 1/4” x 2 1/2” Carriage Bolt (45) into the cen-
ter hole in a Seat Plate (65). Attach the Seat Plate to
a Seat (13) with two 1/4” x 3/4” Bolts (49).
Insert the 1/4” x 2 1/2” Carriage Bolt (45) into the
indicated hole in the Press Seat Frame (7) and tight-
en a 1/4” Flat Washer (71) and a 1/4” Nylon Locknut
(68) onto it. Attach the other end of the Seat (13)
with a 1/4” x 2 1/2” Bolt (79) and a 1/4” Flat Washer.
56
83
82
71
70
83
71
45
68
13
65
49
71
7
49
65
99
101
35
78
2
58. Press 3/4” Round Inner Caps (43) into the ends of
both Pad Tubes (42).
Insert one Pad Tube (42) into the Leg Lever (41).
Slide a Foam Pad (30) onto each end of the Pad
Tube.
Insert the other Pad Tube (42) into the Butterfly Front
Leg (3). Slide a Foam Pad (30) onto each end of the
Pad Tube.
58
43
30
43
43
43
42
42
41
3
30
57
59. Remove the pre-assembled 1/4” x 5/8” Screws (95)
from the Weight Top Frame (66).
Orient one Right Shroud (34) and one Left Shroud
(109) as shown. Attach the Shrouds to the brackets
on the Weight Top Frame (66) with the 1/4” x 5/8”
Screws (95).
59
95
34
66
109
68
79