Filter
Top Products
9
11. Route the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Finger Guards (37) to the indicated hole in
the Base (2) (see the inset drawing) with an M10
x 47mm Button Screw (76) and an M10 Washer
(59).
Make sure that the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
12. Attach a Pulley Bracket (17) to the indicated “U”-
channel (18) with an M10 x 129mm Button Bolt
(72), two M10 Washers (59), and an M10 Nylon
Locknut (56).
Wrap the Long Cable (42) over a 90mm Pulley
(38). Attach the Pulley inside the Pulley Bracket
(17) with an M10 x 41mm Button Bolt (71) and an
M10 Nylon Locknut (56).
13. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Finger Guards (37) to the Base (2) with an
M10 x 47mm Button Screw (76) and an M10
Washer (59).
Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
Note: The Finger Guards (37) attached in this
step will overlap the Finger Guards attached
in steps 8 and 11.
11
12
13
56
56
72
59
71
42
18
59
17
38
42
37
39
Hole
38
59
37
76
2
2
42
37
39
38
59
37
76
2
10. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
t
wo Finger Guards (37) to the Base (2) with an
M10 x 47mm Button Screw (76) and an M10
W
asher (59). M
ake sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pulley.
Note: The Finger Guards (37) attached in this
step will overlap the Finger Guards attached
in step 8.
1
0
42
37
39
38
59
37
7
6
2