Filter
Top Products
10
15. Make sure that the Long Cable (42) is below
the rod in the Swivel Arm (12).
Attach a 90mm Pulley (38) inside the Swivel Arm
(12), under the Long Cable (42), with an M10 x
51mm Button Bolt (74), two M10 Washers (59),
two 5mm Spacers (82), and an M10 Nylon
Locknut (56).
14. Note: This step may be easier if the resistance
system is tipped over forward (see drawing
1
4b).
U
se the wire in the Rear Frame (10) to pull the
Long Cable (42) through the Rear Frame and out
of the Swivel Arm (12).
Have a second persons
hold the cable end until step 15 is completed.
Hold a 90mm Pulley (38) under the Long Cable
(42) as shown. Insert an M10 x 132mm Button
Bolt (69) into a Finger Guard (37), a Cable Trap
(39), the Pulley, an M10 Washer (59), an 8mm
Spacer (41), another Finger Guard, and another
8mm Spacer.
Note: The end of the Bolt must
be flush with the edge of the last spacer. Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
See drawing 14b. Insert the 90mm Pulley (38)
inside the Rear Frame (10). Push the M10 x
132mm Button Bolt (69) through the Rear Frame
and the Right Upright (7). Tighten an M10 Nylon
Locknut (56) onto the Bolt.
Tighten the M10 Nylon Locknuts (56) used in
steps 3 and 7.
16. Attach the Backrest (30) to the Upright Base (5)
and the Uprights (6 and 7) with four M6 x 76mm
Screw (64) and four M6 Washers (60).
74
42
12
38
59
59
56
Rod
15
16
82
82
30
5
6
60
60
60
7
64
64
14a
14b
69
37
39
38
41
41
37
59
42
56
69
38
42
1
2
10
10
7