Filter
Top Products
7
4. Attach the two 10-pound Short Caps (81) to the
10-pound Center Bar (45) with two M4 x 12mm
F
lat Head Screws (58).
U
sing ten M4 x 12mm Flat Head Screws (58),
attach the two 10-pound Caps (53) to the 10-
pound Bar (46), the two 20-pound Caps (52) to
the 20-pound Bar (47), the four 80-pound Caps
(51) to the two 80-pound Bars (48), and the two
40-pound Caps (50) to the 40-pound Bar (49).
5. Turn the Top Tray (14) upside-down. Set the
resistance bars into the Tray in the following
order: 10-pound Bar (46), 20-pound Bar (47), 80-
pound Bar (48), 10-pound Center Bar (45), 80-
pound Bar (48), and 40-pound Bar (49). Make
sure that the resistance bars are centered in
the Tray.
Set the Bottom Tray (13) on top of the Top Tray
(14) to hold the resistance bars in place. Turn the
Trays over and slide them onto the Rear Frame
(10).
Make sure that the Trays and the resist-
ance bars are oriented as shown.
Have a second person attach the Trays (13 and
14) to the Rear Frame (10) with the Tray Cover
(15), two M8 x 100mm Button Bolts (70), two M8
Washers (54), and two M8 Nylon Locknuts (57).
Press the Tray Cap (16) into the Rear Frame
(10).
6. Refer to the CABLE DIAGRAM on page 14
while cabling the resistance system to ensure
correct cable routing. Do not overtighten the
bolts attaching the pulleys; the pulleys must
be able to turn easily.
Insert the Long Cable (42) into the indicated
Swivel Arm (12) and the Rear Frame (10). Make
sure that the Cable is below the rod in the
Swivel
Arm.
Attach a 90mm Pulley (38) inside the Swivel Arm
(12) with an M10 x 51mm Button Bolt (74), two
M10 Washers (59), two 5mm Spacers (82), and
an M10 Nylon Locknut (56).
45
49
4
48
48
4
7
46
58
58
58
58
58
51
51
52
53
58
81
5
0
5
14
13
49
48
45
46
47
70
15
6
10
57
16
54
12
Rod
10
42
38
74
59
59
56
82
82
57