Filter
Top Products
Tohirean authorizedservicetechnicianto assembletheexercise cycJe, call toll-free 1-800-445-2480.
Assembly requires two persons. Hace aH parts of the exercise cycle in a cleared area and remove the packing
matedaUs, Do not dispose of the packing matedaUs until assemMy is compUeted, Assembly requires the included
tools and your own adjustable wrench _ and Phillips screwdriver -j_
Use the drawings beUowto identify the small parts needed for assemMy, The number in parentheses beUoweach
drawing is the key number of the part, from the PART LIST on page 18, The number following the key number is
the quantity needed for assembly, Note: Some small parts may have been preassembled. If a part is not in
the parts bag, check to see if it has been preassemMed.
M8 Nylon MIO Nylon M8 Split Washer M4 x 16mm
Locknut (10)-6 Locknut (33)-4 (41)-10 Screw (49)-4
M8 x 25mm Button
Screw (45)-6
M8 x 38mm Button
Screw (9)-2
MIO x 75mm Carriage Bolt (30)-4
Identify the Front Stabilizer (2), See the inset drawing,
Attach a Wheel (14) to one end of the Front Stabilizer
with an M8 Nylon Locknut (10), Make sure that the
Wheel is oriented as shown and that it turns freely.
Next, align the four plastic posts on a Wheel Cover
(23) with the plastic posts on the Wheel, and press the
Wheel Cover onto the Wheel, Assembte the other
Wheel (not shown} in the same way.
While another person lifts the front of the Frame (1),
attach the Front Stabilizer (2) to the Frame with two
MIO x 75mm Carriage Bolts (30) and two MIO Nylon
Locknuts (33) as shown.
While another person Hftsthe rear of the Frame (1),
attach the Rear Stabilizer (6) with two MIO x 75mm
Carriage Bolts (30) and two MIO Nylon Locknuts (33),
Post
-y
3O