Filter
Top Products
6
3
44
66
56
3. Slide the Rear Frame (44) partially out of the Frame
(1). Set the Seat Rail (7) on the Rear Frame and the
Frame with the indicated holes at the rear of the
cycle. Next, slide the Seat Rail forward until the four
holes in the bracket on the Frame are aligned with
the four holes near the front of the Seat Rail. Finger
tighten four M8 x 15mm Button Screws (27) into the
Frame and the Seat Rail.
Next, slide the Rear Frame (44) forward or backward
until the four holes in the bracket on the Rear Frame
are aligned with the four holes near the rear of the
Seat Rail. Finger tighten four M8 x 15mm Button
Screws (27) into the Rear Frame and the Seat Rail.
Tighten all eight Button Screws.
44
1
27
27
27
7
Holes
6
27
28
28
28
27
27
1
16
20
5
2. Attach the Rear Stabilizer (3) to the Rear Frame (44)
with two M8 x 70mm Carriage Bolts (66), two M8
Curved Washers (28), and two M8 Acorn Nuts (56).
4. While another person holds the Upright (6) near the
Frame (1) as shown, connect the Upper Wire
Harness (16) to the Lower Wire Harness (20). Next,
slide the Upright onto the Frame. Be careful not to
pinch the Wire Harnesses.
Attach the Upright (6) to the Frame (1) with four M8
x 15mm Button Screws (27) and four M8 Curved
Washers (28).
2
28
4
27
3
8
6
63
16
22
54
54
5. While another person holds the Console (8) near
the top of the Upright (6), identify the green console
ground wire and attach it to the Upright with the M4
x 8mm Ground Screw (63). Make sure that the
console ground wire connector is pointed toward
the center of the large square hole as shown.
Connect the Pulse Wires (22) to the corresponding
console wires. Make sure that the Pulse Wire and
console wire with stickers are connected to
each other. The orange console wire must be con-
nected to the right-hand side Pulse Wire. Next, plug
the Upper Wire Harness (16) into the console wire
harness.
Insert all excess wiring down into the Upright
(6). Attach the Console (8) to the Upright with four
M4 x 16mm Button Screws (54).