Filter
Top Products
7
10. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
9
9
Grease
38
14
27
38
63
29
10
9. Hold the lower end of the Left Handlebar (9) against
the Left Pedal Arm (14). Apply grease to an M10 x
92mm Button Bolt (27). Attach the Left Handlebar to
the Left Pedal Arm with the Button Bolt, two M10 Large
Washers (38), and an M10 Nylon Locknut (29). Do not
overtighten the Nylon Locknut; the Left Handlebar
must be able to pivot freely.
Attach the Right Handlebar (10) to the Right Pedal Arm
(not shown) in the same way.
Tighten the M10 x 88mm Button Bolt (63).