Filter
Top Products
5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
A
ssembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , two adjustable
wrenches , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 x 40mm Button
Screw (67)–4
M10 x 20mm Patch
Screw (58)–4
M10 x 25mm
Washer (52)–4
M8 x 16mm Patch
Screw (53)–5
M8 Locknut
(68)–4
19mm Wave
Washer (71)–4
M8 x 25mm Patch
Screw (77)–6
16mm Wave
Washer (66)–4
M8 x 25mm
Washer (54)–8
M4 x 19mm
Screw (75)–4
M4 x 35mm
Screw (74)–2
M4 x 50mm
Screw (76)–4
M10 x 35mm Shoulder
Screw (57)–2
M4 x 16mm
Screw (72)–8
M8 x 50mm Patch
Screw (65)–2