Filter
Top Products
11
37
Grease
38
58
46
46
52
52
39
71
31
11. Apply a generous amount of grease to the axle
on the Right Upper Body Arm (37) and to the
right Crank Arm (31).
Apply a small amount of grease to two 19mm
W
ave Washers (71). Slide one Wave Washer
onto the Right Upper Body Arm (37); slide the
other Wave Washer onto the right Crank Arm
(31).
Identify the Right Pedal Leg (38) and Right Link
Arm (39) assembly, which is marked with an “R”
sticker. Orient the assembly as shown.
At the same time and with the help of another
person, slide the Right Pedal Leg (38) onto the
Right Upper Body Arm (37) and slide the Right
Link Arm (39) onto the right Crank Arm (31).
Attach the Right Pedal Leg (38) and the Right
Link Arm (39) with two M10 x 20mm Patch
Screws (58), two Axle Covers (46), and two M10
x 25mm Washers (52).
Repeat this step for the other side of the
elliptical exerciser.
12. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
11