Filter
Top Products
8
8. The Console (6) requires four “AA” batteries (not
included). Alkaline batteries are recommended.
To install batteries, look under the Console (6) and
locate the two Battery Covers (9) (there is one Battery
Cover on each side). Remove the Battery Covers by
sliding them in the direction shown by the arrows on
the Battery Covers. Insert two batteries into each bat-
tery compartment; make sure that all four batteries
are turned so the negative ends (marked “–”) are
touching the springs in the battery compartments.
Then, reattach the Battery Covers by sliding them in
the opposite direction.
9. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical
trainer to protect the floor or carpet from damage.
6
8
Batteries
9
7. Slide a Weld Spacer (49) onto the left axle on the
Upright (3). Make sure that the open side of the Weld
Spacer is facing the Upright.
Apply a thin film of the included grease to the axles
and the Crank Arms (59) in the locations indicated.
Slide a Pedal Arm Spacer (41) onto the left Crank
Arm (59). Make sure that there are two Rear Pedal
Arm Bushings (11) in the Pedal Arm (12) attached to
the Left Handlebar (8).
With the help of another person, slide the Left
Handlebar (8) onto the left axle on the Upright (3)
while sliding the left Pedal Arm (12) onto the left
Crank Arm (59). Note: These parts fit tightly; it may be
helpful to use a rubber mallet. In addition, it may be
helpful to rotate the left Crank Arm (59) to a different
position.
Tap a 5/8” Axle Cap (57) onto the left axle on the
Upright (3). Tap a 3/4” Axle Cap (43) onto the left
Crank Arm (59).
Repeat this step to attach the Right Handlebar and
the right Pedal Arm (not shown).
7
59
41
11
12
49
57
3
43
8
Grease
Grease
Grease