Filter
Top Products
16
ATTACHING THE HANDLES TO THE UPPER AND
LOWER PULLEY STATIONS
To use the upper pulley station (see drawing A) or lower
pulley station (see drawing B), weight must first be placed
on the weight carriages (see ATTACHING WEIGHTS TO
THE WEIGHT CARRIAGES above).
The Handles (36) can be attached to the Cables (45) with
the Cable Clips (64) as shown.
The Ankle Strap (55) can be attached to the Cables (45)
in the same manner.
A
55
64
45
36
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGES
To use the upper or lower pulley stations, slide the
desired amount of weight (not included) onto the weight
tube of one of the Weight Carriages (37). If you are using
olympic weights, you will need to use a Weight Adapter
(48). See assembly step 13 for instructions.
If the exercise you are performing requires both Weight
Carriages (37), make sure there is an equal amount of
weight on both Weight Carriages.
48
37
B
55
64
36
45
WARNING: Do not place more than 150 pounds on
each weight carriage.
SECURING WEIGHTS WITH THE SPRING CLIPS
When you have attached weights (not included) to the
Barbell (74), Weight Carriages (37) or Leg Lever (18, not
shown), always secure them with a Spring Clip (76) or 1Ó
Spring Clip (78).
Note: The Spring Clips (76) are for use with olympic
weights and the 1Ó Spring Clips (78) are for use with
regular weights.
37
76
74
78