Filter
Top Products
3. With the help of a second person, hold the Console Base
(6) and the Right Handrail (32) near the right Upright (14)
as shown. Route the Console Wire Harness (92) through
the bracket on the Right Handrail.
Refer to the inset drawing. Slide the Strain Relief Clip
(88) onto the Console Wire Harness (92). Make sure that
there is no slack in the Console Wire Harness between
the Strain Relief Clip and the Console Base (6). Insert a
3/4” Screw (91) into the Strain Relief Clip and into the in-
dicated hole in the Right Handrail (32). Tighten the Screw
into the Console Base.
4. With the help of a second person, hold the Pulse
Handrail (8) near the right Upright (14) as shown. Route
the Pulse Wires through the bracket on the Right
Handrail (32).
Connect the Console Wire Harness (92) to the Upright
Wire Harness (26). Connect the Pulse Wires to the
Console Wire Harness (92) as shown in the inset draw-
ing. Make sure that the wires with tags are connected
to each other.
Position the Pulse Handrail (8) between the Left and
Right Handrails (2, 32) as shown. Insert all wires into the
right Upright (14). Insert the bracket on the Right
Handrail (32) into the right Upright (14). Make sure that
the wires are not pinched.
5. Using the included allen wrench, attach the Pulse
Handrail (8) to the Left and Right Handrails (2, 32) with
two Pulse Handrail Bolts (97) and Handrail Washers (16).
6. Attach the Console Base (6) to the Left and Right
Handrails (2, 32) with three 3/4” Screws (91).
6
91
6
91
2
32
6
8
97
16
97
16
5
4
26
92
92
2
32
14
26
8
Bracket
32
2
Pulse
Wires
Pulse
Wires
92
Bracket
32
91
91
92
14
3
6
88
88
32
6
IMPORTANT: The Strain Relief Clip (88) must be
attached as instructed.