Filter
Top Products
9
10. Identify the Left Pedal (22), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal
counterclockwise
into the Left Crank
Arm (24). Tighten the Right Pedal (not shown)
clockwise
into the Right Crank Arm (not shown).
IMPORTANT: Tighten both Pedals as firmly as
possible. After using the exercise cycle for one
week, retighten the Pedals.
Adjust the strap on the Left Pedal (22) to the
desired position, and press the end of the strap
onto the tab on the Left Pedal. Adjust the Right
Pedal Strap (not shown) in the same way.
10
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
9. Push the seat handle down. Pull the Seat Carriage
(41) towards the back of the exercise cycle until it
stops. Then, pull up on the seat handle to lock the
Seat Carriage in place.
While another person holds the Seat Bracket (11)
near the Seat Carriage (41), connect the Right
Controller Wire (82), which has a tag attached, to
the wire on the Rear Wire Harness (51) that has a
tag attached. Then, connect the Left Controller Wire
(61) to the other wire on the Rear Wire Harness.
Make sure that the connectors on the Controller
Wires (61, 82) are positioned side by side under
the plastic cover on the Seat Bracket.
Be careful to avoid pinching and damaging the
wires. Attach the Seat Bracket (11) to the Seat
Carriage (41) with four M8 x 19mm Button Screws
(77) and four M8 Split Washers (55).
22
Strap
Tab
24
11
61
41
51
82
77
77
Plastic
Cover
Seat
Handle
55
55
9
Avoid pinching and
damaging the wires