Filter
Top Products
13
To use the manual mode of the console, see the
instructions below. To use a Smart program, see
page 15. To use a Heart Rate program, see page
16. To use the Watts program, see page 18. To use
an iFIT.com CD program, see page 19. To use an
iFIT.com video program, see page 22. To use a pro-
gram directly from our Web site, see page 23.
HOW TO USE THE MANUAL MODE
Turn on the console.
Make sure that the transformer is plugged in or
that batteries are installed in the console (see
assembly step 12 on page 9).
To turn on the console, press the On/Reset button
or begin pedaling. (The On/Reset button is the
button above the left side of the large display.)
Select the manual mode.
Each time the console is
turned on, the manual
mode will be selected. If a
program has been select-
ed, reselect the manual
mode by pressing the
Program button repeated-
ly until the letters RPM
appear in the small display.
Begin pedaling and change the resistance of
the pedals as desired.
As you pedal, change the resistance of the ped-
als by pressing the Resistance + and – buttons.
There are ten resistance levels; level 10 is the
most challenging. Note: After the buttons are
pressed, it will take a few seconds for the resis-
tance to reach the selected level.
Follow your progress with the large display and
the small display.
The upper sec-
tion of the large
display will
show the dis-
tance you have
pedaled and the
numbers of
calories
and
fat calories
you have
burned (see FAT BURNING on page 25). The dis-
play will change from one number to the next
every few seconds. When you use the handgrip
pulse sensor or wear the optional chest pulse
sensor, the display will also show your heart rate
(see step 5 on page 14).
The centre of the
large display will
show the elapsed
time and your
pedaling pace (in
minutes per mile).
The display will change from one number to the
other every few seconds. Note: When a program
is selected (except for the Watts program and
Heart Rate program 2), the display will show the
time remaining in the program instead of the
elapsed time.
The lower sec-
tion of the large
display will show
your pedaling
speed, your ped-
aling pace (in rev-
olutions per minute), and the resistance level.
The display will change from one number to the
next every few seconds.
Note: The con-
sole can show
speed and dis-
tance in either
miles or kilome-
ters. The letters
MPH or KM/H will appear in the lower section of
the large display to show which unit of measure-
ment is selected. To change the unit of measure-
ment, first hold down the Program button for a few
seconds. An E (for English) or an M (for metric) will
appear in the lower section of the large display.
Press the Resistance + button to change the unit
of measurement. Then, press the On/Reset button.
Note: When the batteries are replaced, it may be
necessary to reselect the desired unit of measure-
ment.
The small display will
show your pedaling pace
(in revolutions per minute).
The indicator bar in the
small display will increase
or decrease in length as
you increase or decrease
your pedaling pace.
4
3
2
1
Indicator Bar