Filter
Top Products
6
4. Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Wire Harness (42) up into the
bracket on the Right Handrail and out of the large hole in
the left side. (Note: It may be helpful to use needlenose
pliers to pull the Wire Harness out of the large hole.)
Press a Handrail Cap (76) onto the lower end of the
Right Handrail as shown.
Insert the bracket on the Right Handrail (72) into the top
of the right Upright (69) so the Handrail Cap (76) is rest-
ing against the Upright. Attach the Right Handrail and the
Handrail Cap with three 1” Bolts (37) and two Washers
(38) as shown. Firmly tighten the indicated Bolt but
do not tighten the other Bolt yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
5. Attach the end of the ground wire to the small hole in the
side of the Right Handrail (72) with a Silver Ground
Screw (75).
Bracket
76
72
69
42
Ground
Wire
72
75
4
5
38
38
37
37
37
Large
Hole
3. With the help of a second person, raise the Uprights (69)
to the vertical position. Attach the Storage Latch (36) to
the left Upright with two 3/4” Screws (2).
Remove the Lock Knob (30) from the Lock Pin (35).
Make sure that the Lock Pin Collar (33) and the Spring
(32) are on the Lock Pin as shown. Insert the Lock Pin
into the Storage Latch (36) and tighten the Lock Knob
back onto the Lock Pin.
35
33
32
36
30
69
2
3
Tighten