Filter
Top Products
14
H
OW TO USE CUSTOM PROGRAMS
I
nsert the key into the console.
S
ee HOW TO TURN ON THE POWER on page
10.
S
elect one of the custom programs.
To select a custom program, press the Program
Select button repeatedly until “P1” or “P2” appears
in the display. A few seconds after a custom pro-
gram is selected, the maximum speed setting of
the program
and the
maximum
incline set-
ting of the
program will
flash in the
display for a
few sec-
onds; in ad-
dition, the display will show how long the program
will last. The matrix in the lower part of the display
will show the first seven speed settings of the pro-
gram.
Note: If only three columns of indicators ap-
pear in the matrix, see HOW TO CREATE A
CUSTOM PROGRAM on page 13.
Press the Start button or the Speed increase
button to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings that you programmed previously.
Hold the handrails and begin walking.
Each custom program is divided into several one-
minute segments. One speed setting and one in-
cline setting are programmed for each segment.
(The same speed setting and/or incline setting
may be pro-
grammed
for two or
more con-
secutive
segments.)
The speed
setting for
the first segment will be shown in the flashing
Current Segment
column of the matrix. (The in
-
cline settings are not shown in the matrix.) The
speed settings for the next four segments are
shown in the columns to the right.
When only three seconds remain in the first seg-
m
ent of the program, both the Current Segment
column and the column to the right will flash, a
series of tones will sound, and the speed setting
and the incline setting will flash in the display.
When the first segment ends,
all speed settings
will move one column to the left
. The speed setting
for the second segment will then be shown in the
flashing Current Segment column, and the tread-
mill will automatically adjust to the second speed
and incline settings that you programmed previ-
ously.
The program will continue in this way until the
speed setting for the last segment is shown in the
Current Segment column and the last segment
ends. The walking belt will then slow to a stop.
If desired, you can redefine to the program while
using it.
To change the speed or incline setting
for the current segment, simply press the Speed
or Incline buttons. When the current segment ends,
the new setting will be saved in memory. To in-
crease the length of the program, first wait until
the program is completed. Then, press the Start but-
ton and program speed and incline settings for as
many additional segments as desired. When you
have added as many segments as desired, press
the Stop button twice. To decrease the length of
the program, press the Stop button twice at any
time before the program is completed.
To stop the program temporarily, press the Stop
button. To restart the program, press the Start but-
ton or the Speed increase button.
Follow your progress with the display.
See step 5 on page 10.
Measure your heart rate if desired.
See step 6 on page 11.
Turn on the fan if desired.
See step 7 on page 11.
When you are finished exercising, remove the
key from the console.
See step 8 on page 11.
7
6
5
4
3
2
1
Current Segment