Filter
Top Products
3. With the help of a second person, carefully tip the 3
Uprights (64) back to the vertical position. 115 32
Attach the Latch Assembly (32) to the left Upright (64)
with two Latch Screws (115).
4. Orient one of the Handgrip Extensions (34) as shown and
insert it as far as possible into the post on the left Upright
(64). If necessary, tap the Handgrip Extension with a rub-
ber mallet to fully insert it. Attach the Handgrip Extension
with two Extension Screws (35), one towards the front of
the post, and the other towards the back.
Attach the other Handgrip Extension to the post on the
right Upright (not shown) in the same way.
5. See the inset drawing. Identify the Left Top Handgrip
(31); there are identifying marks inside of the Handgdps.
Set the Left Top Handgdp on the left Handgdp Extension
(34). Insert two 1/2" Screws (33) into the two holes in
the Handgrip Extension indicated by the arrows.
Tighten the Screws into the Left Top Handgrip.
Important: Do not insert the two 1/2" Screws (33) into
the wrong holes in the Handgrip Extension (34), or
tighten the Screws into the plastic bosses on the bot-
tom of the Left Top Handgrip (31).
4 Post
35 ---_ ....
34 ..
35
6. Attach the matching Left Bottom Handgdp (104) with
three 1/2" Screws (33).
Attach the Right Top Handgrip and the Right Bottom
Handgrip (not shown) as described above.
Remove the plastic ties from the Upper Body Arms (not
shown).
k
33
104
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the amenwrench is used to adjust the walking belt (see page 25), To protect the
floor or carpet from damage, place a mat under the treadmill.
7