Filter
Top Products
Locate the Reed Switch (18) and the Magnet (101) on
the left side of the Pulley (78). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". If necessary, loosen the 3/4"
Screw (24) and move the Reed Switch slightly.
Retighten the Screw. Re-atlach the hood, and run the
treadmill for a few minutes to check for a correct
speed reading.
[
I
1/8"-
Top
View
i+11
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the allen wrench, turn both
rear roller adjustment bolts counterclockwise, 1/4 of a
tum. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 3 to
4 inches off the walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in-
sert the key and run the treadmill for a few minutes.
Repeat until the walking belt is propedy tightened.
b
Rear Roller Adjustment Bolts
c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, first remove the key
and UNPLUG THE POWER CORD. If the walking a _lk .._j_
belt has shifted to the left, use the allen wrench to
turn the left rear roller boltclockwise 1/2 of a turn; if
the walking belt has shifted to the right, turnthe
bolt counterclockwise 1/2 of a turn. Be careful not to
overtighten the walking belt. Plugin the power cord,
insert the key, and run the treadmill for a few minutes.
Repeat untilthe walking belt is centered.
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn. When the walking belt is correctlytight-
ened, you should be able to lifteach side of the walk-
ing belt 3 to 4 inches offthe walking platform. Be
careful to keep the walking belt centered. Plug in the
power cord, insert the key and carefully walk on the
treadmill for a few minutes. Repeat untilthe walking
belt is properly tightened.
PROBLEM: The incline of the treadmill does not change correctly or does not change when iFITocom
CDs and videos are played
SOLUTION: a. With the key inserted in the console, press one of the Incline buttons. While the Incline is
changing, remove the key. After a few seconds, re-inserf the key. The treadmill will automati-
cally riseto the maximum inclinelevel and then return to the minimum level. This will recalibrate
the incline.
25