Filter
Top Products
HOW TO USE A PRESET WORKOUT
1. Turn on the console.
Press any button or begin pedaling to turn on the
console.
When you turn on the console, the display will light.
A tone will sound and the console will be ready for
use.
2. Select a preset workout.
To select a preset work-
out, press the 7 Wt. Loss
Workouts button or the 7
Perform. Workouts button
repeatedly until the num-
ber of the desired workout
appears in the lower display.
Profile
When you select a preset
workout, a profile of the
resistance levels of the
workout will scroll across
the upper display, the duration of the workout will
appear in the center display, and the number of the
workout will appear in the lower display.
3. Begin pedaling to start the workout.
Each workout is divided into several one-minute
segments. One resistance level and one goal
speed is programmed for each segment. Note: The
same resistance level and/or goal speed may be
programmed for consecutive segments.
During the workout, the workout profile will show
your progress (see the drawing above). The flash-
ing segment of the profile represents the current
segment of the workout. The height of the flashing
segment indicates the resistance level for the cur-
rent segment.
At the end of each segment of the workout, a
series of tones will sound and the next segment of
the profile will begin to flash. If a different resis-
tance level is programmed for the next segment,
the resistance level will appear in the display for
a few seconds to alert you. The resistance of the
pedals will then change.
As you exercise, keep your
pedaling speed near the goal
speed for the current seg-
ment. The goal speed will
appear in the display when
the speed display mode is
selected.
RESISTANCE
F1 t
9uRL
TiME
fS.
SPEED
IMPORTANT." The goal
speed is intended only to
provide motivation. Your
actual pedaling speed may be slower than the
goal speed. Make sure to pedal at a speed that
is comfortable for you.
If the resistance level for the current segment is
too high or too low, you can manually override
the setting by pressing the Resistance buttons.
IMPORTANT." When the current segment of the
workout ends, the pedals will automatically
adjust to the resistance level programmed for
the next segment.
If you stop pedaling for several seconds, a series of
tones will sound and the workout will pause.
To resume the workout, simply resume pedaling.
The workout will continue until the last segment
of the profile flashes and the last segment of the
workout ends.
4. Follow your progress with the display.
See step 4 on page 14.
5. Measure your heart rate if desired.
.
See step 5 on page 15.
When you are finished exercising, the console
will turn off automatically.
See step 6 on page 15.
16