Filter
Top Products
,
Orient the Console Plate (19) and the Handlebar
(47) as shown. Have a second person hold
the Console Plate and the Handlebar near the
Upright (3).
Locate the Pulse Wire (52) in the Handlebar
(47). Insert the Pulse Wire into the hole in the
Upright (3), and then pull it upward out of the top
of the Upright.
Then, insert the Main Wire (31) and the Pulse
Wire (52) upward through the Console Plate
(19).
47---.
31
\
19
10. Tip: Avoid pinching the wires. Insert the
Console Plate (19) into the Upright (3).
Attach the Handlebar (47) and the Console
Plate (19) to the Upright (3) with two M8 x 25mm
Button Screws (44) and two M8 Split Washers
(45).
10
Avoid pinching
the wires
19
45
11. The Console (6) can use four D batteries
(not included); alkaline batteries are recom-
mended, iMPORTANT: if the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert=
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Remove the screws and the battery covers
from the back of the Console (6), and insert
batteries into the battery compartments. Make
sure to orient the batteries as shown by the
diagrams inside the battery compartments.
Then, reattach the battery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console, use
only a manufacturer=supplied power adapter.
Plug one end of the power adapter into the
receptacle on the console; plug the other end
into an outlet installed in accordance with all
local codes and ordinances.
11
Battery
Cover
6
\
y
Cover
10