Filter
Top Products
12
13. Partially tighten two M8 x 25mm Bolts (4) with
two M8 Star Washers (9) into the Left Upright
(79) and the Left Handrail (21); do not fully
tighten the Bolts yet.
Next, partially tighten two M8 x 25mm Bolts (4)
with two M8 Star Washers (9) into the Right
Upright (80) and the Right Handrail (100). Then,
tighten all four Bolts.
See steps 5 and 8. Tighten the M10 x 96mm
Bolts (7).
Console
Assembly
4
79
80
4
4
4
9
9
9
9
2
1
100
13
14. Remove the Resistance Knob (88) from a resis-
tance mechanism. Make sure that the 3/8" x 4
3/4" Bolt (3) stays inside the resistance
mechanism and that the resistance mecha-
nism does not come apart. Note: See the
lower drawing to reassemble the resistance
mechanism if necessary.
Apply a small amount of the included grease
around the Resistance Cone (85) and Upright
Insert (84).
Insert the Resistance Cone (85) into the Upright
Insert (84) in the Left Upright (79), with the two
large holes on top as shown. Then, tighten the
Resistance Knob (88) onto the 3/8" x 4 3/4" Bolt
(3). Do not fully tighten the Resistance Knob.
Attach the other resistance mechanism to
the Right Upright (80) as described above.
88
Large
Holes
Resistance
Mechanism
3
88
84
80
Large
Holes
85
3
79
14