Filter
Top Products
10
8. Hold a Bolt Spacer (98) inside the lower end of
the Left Upright (79). Insert an M10 x 96mm Bolt
(7) with an M10 Star Washer (8) into the Left
U
pright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (98), M10 x 96mm
B
olt (7), and M10 Star Washer (8).
Orient the Left Upright (79) and the Left Upright
Spacer (89) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(99). Tighten the M10 x 96mm Bolts (7) until the
heads of the Bolts touch the Upright; do not fully
tighten the Bolts yet.
89
79
7
99
9
8
8
8
9. Press a Base Cap (91) into the Base (99).
With the help of a second person, tip the treadmill
so that the Base (99) is flat on the floor.
91
99
9
10. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly.
Identify the Right Handrail (100) which is
marked with a sticker. Hold the Right Handrail
near the console assembly. Attach the console
ground wire to the Right Handrail with a #8 x
1/2" Ground Screw (29).
Next, insert the console wire into the large hole
in the Right Handrail (100) and pull it out of the
top as shown. Attach the Right Handrail with
three #8 x 3/4" Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
Remove the ties from the M8 Cage Nuts (39). If
necessary, press the Cage Nuts back into place.
100
39
10
1
1
1
Large Hole
Console
Wire
29
Console
Ground Wire
Console
Assembly