Filter
Top Products
8
5. Insert the tab on one of the Handrail Brackets (5)
into the slot in the right Upright (69). Attach the
H
andrail Bracket with a 3/4" Screw (2). A
ttach
the other Handrail Bracket to the left Upright
(
not shown) in the same way.
6. Set the Console (43) face-down on a soft sur-
face to avoid scratching the Console. Next, hold
a Handrail (71) near the Console. Insert the con-
sole wire into the hole in the side of the Handrail
and out of the hole in the top as shown. Then,
attach the ground wire to the Handrail with a
Silver Ground Screw (96).
Set the Handrail (71) on the Console (43).
Attach the Handrail with three 3/4" Screws (2).
Make sure that the console wire is not
pinched. Start all three Screws before tight-
ening any of them; do not overtighten the
Screws. Insert the excess ground wire into the
opening in the Console.
Attach the other Handrail (not shown) to the
Console (43) as described above. Note: There
are no wires on the other side.
6
2
69
5
Slot
5
71
96
43
Console Wire
Ground Wire
2
2
2
7. Remove the tie holding the Wire Harness (42) to
the right Upright (69). With the help of a second
person, hold the Console (43) near the right
Upright.
Connect the Wire Harness (42) to the console
wire.
Make sure to connect the connectors
properly (see the inset drawing). The connec-
tors should slide together easily and snap
into place.
If the connectors do not slide to
-
gether easily and snap into
place, turn one con
-
nector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Then, insert the con-
nectors and the excess wire into the right Upright
(69).
69
42
43
7
42
Console
Wire
Console
Wire