Filter
Top Products
7
2. Identify the Right Upright (92), which is marked
with a “Right” sticker.
H
ave a second person hold the Right Upright
(92) near the Right Base Cover (102). See the
i
nset drawing. Tie the wire tie in the lower end
of the Right Upright securely around the end of
the Upright Wire (93). Then, pull the other end
of the wire tie in the top of the Right Upright until
the Upright Wire is routed through the Right
Upright.
Gently pull up on the Upright Wire (93) as you
set the Right Upright (92) on the Base (103) in-
side the Right Base Cover (102). Be careful not
to pinch the Upright Wire.
Attach the Right Upright (92) to the Base (103)
with two 3/8" x 3 3/4" Bolts (5) and two 3/8" Star
Washers (6). Note: It may be necessary to tip
the top of the Right Upright forward slightly as
you thread the Bolts into it. Do not tighten the
Bolts yet.
Attach the Left Upright (91) in the same way.
Note: There are no wires on the left side.
103
93
102
2
92
6
5
91
93
92
Wire
T
ie
Wire
Tie
3. With the help of a second person, lower the
treadmill off the cardboard stand. The stand will
be used again in assembly step 9.
Identify the Right Upright Sleeve (90) and the
Left Upright Sleeve (89), which are labeled
“Right” and “Left.”
Slide the Right Upright Sleeve (90) onto the
Right Upright (92), and slide the Left Upright
Sleeve (89) onto the Left Upright (91).
89
“Right”
Cardboard
Stand
“Left”
90
3
92
91